Wednesday, September 1, 2004 at 5:00 PM
Edited Wednesday, September 1, 2004 at 5:17 PM Finally somone responds! I listen to loveline on WXTM 92.3 Cleveland Heights, Cleveland. The only cue tone that will always be heard is the one to start local spots. So it would be good to use it to pause a recorder for a certain ammount of time and start again. Ive been looking at some radio automation software and can feel that Im getting close to one that will decode the tones from a non sub audio source I.E the radio while recording it. Also, I just found a device that will generate the cue tones, but not decode them.
http://www.monroe-electronics.com/Products/935A.pdf —24/7KROQ | 
